Erie Lackawanna 'erielack' E-Mail List Photo Archive

DL_W-70t-Hopper-MM.jpg   Original: 542 by 244 pixels - Current: 542 by 244 - 100%
                          Try your mouse wheel too!

(No Previous Image) End-sheet-tapers-MM.jpg - Next Image

From: "William E DOT Botkin" webotkin AT ecentral DOT com
Date: Fri, 30 Nov 2007 08:48:00 -0700
Subject: Upcoming HO models - DL&W 70 ton Hopper
"DL_W-70t-Hopper-MM.jpg" - image/jpeg, 542x244 (24bit)

Paul, Tom and all,

Here is the prototype photo of this DL&W 70t hopper. The full article about
these is in Mainline Modeler, August 1987.

----- Original Message -----
From: "Tupaczewski, Paul R (Paul)"
To: "EL Mail List"
Sent: Friday, November 30, 2007 7:20 AM
Subject: RE: (erielack) Upcoming models

> I'm not sure if the car is 100% accurate for DL&W, but the Lackawanna
> DID have offset-side 3-bay hoppers... I'll defer to other DL&W freight
> aficionados (Mike D?) to answer that one.
> The lettering on this model is a little on the "weak" side, IMHO...
> - Paul
>> -----Original Message-----
>> From: Tom Schmieder []
>> Hey Paul,
>> Speaking of upcoming models, did you see Accurail's listing
>> of the 3-bay 70 ton offset side hoppers decorated for DL&W?
>> Do you know if these cars are correct? They only have a
>> single car available, DL&W #84016. Here's the link...
>> Tom
> The Erie Lackawanna Mailing List
> Sponsored by the ELH&TS
> To Unsubscribe:
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.503 / Virus Database: 269.16.11/1161 - Release Date:
> 11/30/2007 12:12 PM


Click Here or on the corner X to close this window.

    All photos are the property of the original photographer unless otherwise noted and are to be used for personal viewing purposes only.

    The use of these photos on any website or other distribution media is strictly forbidden without the express consent of the image copyright holder.

    Linking directly to this page is permitted as long as " Erie Lackawanna Email List Photo Archive" is creditted on the linking page.